News
Notes on machine parts replacement of computerized quilting machine
Date:2017-11-01Pay attention to the following points when changing machine parts of computerized quilting machine:
1. The repair and replacement parts shall be operated by experts as much as possible. If you don't understand, you must not dismantle them by mistake;
2. The repaired or replaced parts shall be provided or approved by the original factory, and can only be replaced and tested if the models are relative;
3. When replacing the computer quilting machine parts, if it is necessary to open the electric control box, be sure to cut off the power supply and wait for another five minutes to operate, do not wet your hands;
4. Use professional tools and strictly follow the instructions to enter the quilting machine for parts replacement. The machine shall be placed safely during the replacement operation;
5. Check again after the replacement. Confirm whether there is any contact between solder and other quilting machine parts, and the insulating material on the circuit board shall be restored to its original state; whether the contact between the line terminal and the plug is good, whether the screw nut is free of operation and falling off, and whether the fastening is free of looseness;
6. After the parts of the computerized quilting machine are replaced, they shall be put into normal operation after trial operation. During the trial operation, it shall be noted that the hair and clothes shall not contact the belt pulley and belt, and safety measures shall be taken.